Audiovox stereo wiring diagram
AUDIOVOX CP-250
AUDIOVOX AV-220
Diagram wiring, wiring diagram, car radio wiring diagram.
Audi Car Stereo Wiring Diagram
AUDI GAMMA
 | A | B | C |
1-Gala | 1-Speaker RR+ (not all models) | 1-Data | |
2-Gnd | 2-Speaker RR- (not all models) | 2-Clk | |
3-Control+12V | 3-Speaker RF+ | 3-Ena | |
5-Power Antenna Turn On | 4-Speaker RF- | 5-Gnd | |
6-Dash Light Dimmer Wire | 5-Speaker LF+ | 6-Control+12V | |
7-+12 VOLT IGNITION WIRE | 6-Speaker LF- | 7-Line out RF | |
8-Gnd | 7-Speaker LR+ (not all models) | 8-Line out RR | |
- | 8-Speaker LR- (not all models) | 9-Line out LF | |
- | - | 10-Line out LR |
Alpine Car Stereo Wiring Diagram
ALPINE TDE-7823W
 | 1-+12 Volt Battery Wire | 9-Gnd |
2-Speaker LR- | 10-Speaker LF- | |
3-Speaker LR+ | 11-Speaker LF+ | |
4-Speaker RR- | 12-Speaker RF- | |
5-Speaker RR+ | 13-Speaker RF+ | |
7-Booster | 16-+12 VOLT IGNITION WIRE | |
8-Power Antenna Turn On | - |
ALPINE 7190M
 | 2-Booster | 28-Speaker LF+ |
8-Gnd- Line out | 29-Gnd | |
9-Line out R | 31-+12 Volt Battery Wire | |
10-Line out L | 32-+12 VOLT IGNITION WIRE | |
13-Power Antenna Turn On | 34-Speaker RR+ | |
26-Speaker LR+ | 35-Speaker RR- RF- | |
27-Speaker LR- LF- | 36-Speaker RF+ |
ISO Car Radio Connectors
|
| ISO
| B 1 Right Rear + |
| B 2 Right Rear - | ||
| B 3 Right Front + | ||
| B 4 Right Front - | ||
| B 5 Left Front + | ||
| B 6 Left Front - | ||
| B 7 Left Rear + | ||
| B 8 Left Rear - | ||
| ISO
| A 1 GALA Geschwindigkeitsabhängige Lautstärkeranpassung or SCV speed-dependent volume control. | |
| A 2 Mute from Cell-Phone | ||
| A 3 RFLS Ruckfahrtlichtschalter - the reversing light switch. | ||
| A 4 Memory Power (12V direct from Battery) | ||
| A 5 Power for Electric Antenna | ||
| A 6 Dial-light illumination (car side light circuit) | ||
| A 7 +12V Main Power (Switched via Ignition key) | ||
| A 8 Ground (Chassis) |
Attention:
The connector wiring may vary depending on the car manufacturer, even when ISO connectors are used. We recommend to check the car’s wiring provision before connecting the car stereo.
Please pay particular attention to pin 5, where a misconnection might cause damage to the car or radio.
Take special care when installing into ’98 or later VW/Audi/Skoda/Seat models as there may bea 12 V connection on Pin 5, which could damage the car stereo or into Ford from ’97 or later , with an ISO connector, on which damage to the car’s microcomputers is possible if misconnected.
Use of ISO connector adapters available on the market may facilitate installation.
ISO 10,487 is a standard 8-pin connector that is used in Autoradio device (head unit). There are contacts for the power cord, off / on (controlled ignition key), the speakers and automatic antenna.
| ISO Connector A napajanje |
| PIN 1 - GALA Geschwindigkeitsabhängige Lautstärkeranpassung - or SCV speed-dependent volume control. |
| PIN 2 - Mute control - this pin is used to mute the sound car, uzemljuje it out some other component such as a mobile phone that is connected to the car. |
| PIN 3 - RFLS Ruckfahrtlichtschalter - the Reversing light switch. Satellite navigation uses this signal, GALA signal (pin 1) and internal laser gyroscope to calculate in the absence of satellite signals. +12 V input on the car involved contact with the lock on the ignition and the car's speed to move backwards. |
| Pin 4 - +12 V with fixed batteries - power for Autoradio. Autoradija linking directly to the battery, it is not necessary to have the key in the ignition lock. Autoradio Some modern devices have an automatic exclusion. This connector connects the memory Autoradio. |
| PIN 5 - automatic antenna - exit from the car +12 V maximum 150 - 300mA power supply automatic or electronic antennas. If there has to be connected, although not automatic antenna. He also manages a sound signal, which warns that the door is open. |
| PIN 6 - light +12 V input on autoradiju when the lights turned on. In some car really shines on display - the other can be dark lighting, replace the relationship between black and white, or even changes color from green to orange. If the dashboard of the car has a brightness control function, this pin must be connected in order to be able to regulate the brightness. Wire lighting the cigarette lighter can be used for. |
| PIN 7 - +12 V with the ignition key when the key in the lock to ON or ACC position. |
| PIN 8 - uzemljenje, chassis, minus 12V |
| ISO Konektor B - zvučnici |
|
· Pin 1 - Right rear speaker + zadnji desni zvučnik + · Pin 2 - Right rear speaker - zadnji desni zvučnik - · Pin 3 - Right front speaker + prednji desni zvučnik + · Pin 4 - Right front speaker - prednji desni zvučnik - · Pin 5 - Left front speaker + lijevi prednji zvučnik + · Pin 6 - Left front speaker - lijevi prednji zvučnik - · Pin 7 - Left rear speaker + lijevi zadnji zvučnik + · Pin 8 - Left rear speaker - lijevi zadnji zvučnik -
|
| B connector is used only for the speakers. Which wire goes to which speaker can be easily determined with a battery of 1.5 V. Speaker will click and you will move forward or backward membrane. Speakers must be properly fazirani (note the + and - half to the speaker), because otherwise you will have weak bass. Speaker wires are in pairs, with a stripe wire is the + pole speakers. |
| C1 - external amplifier or equaliser |
|
|
| C2 - remote control |
|
|
| C3 - CD changer |
|
|
| ISO connector C |
| Connector C are actually three separate connectors that are užlijebljena together. It is not always present, sometimes only a part. It is usually connected to the device which supports. |
Subscribe to:
Posts (Atom)