Depending on your car's factory electrical system, you may not have enough power to run your aftermarket stereo system. You probably do unless you have a multi-megawatt system or an extremely tiny alternator. If your battery goes dead often after the installation of your new stereo you may have an electrical system problem. Have your battery and electrical system tested by a qualified technician. If everything checks out then you probably are in need of an upgrade. Here are some of the common problems and their likely cures.
Adding a Second Battery
Many people are under the impression that adding a second battery will cure their electrical

Upgrading Your Alternator
Frequent dead batteries are a good indication that your electrical system isn't keeping up and you may need to upgrade your alternator. Doing so will give you more juice to run all of your electrical components, including your stereo system, without looking to the battery for help. The problem is your alternator is undersized for your new electrical requirements and has to look to

Power Capacitors
Another solution is to add a power or Stiffening™ capacitor. This device acts as an electrical storage "buffer". It stores power until needed for high electrical demands such as heavy bass
notes. If your headlights dim when you have you stereo cranked then you MAY benefit from one of these. This is most noticeable when music with a heavy beat is played. Your headlights will dim to the beat. This is being caused by a voltage drop that is being created by the large power demands of your amplifier(s). A power capacitor will help fill in the gaps in the energy required by your amplifiers. Because of their low internal resistance they can deliver a lot of power much more quickly than a battery can and can often prevent this voltage drop.
Another solution is to add a power or Stiffening™ capacitor. This device acts as an electrical storage "buffer". It stores power until needed for high electrical demands such as heavy bass

0 comments:
Post a Comment